Diese Seite wurde mit Google Übersetzer übersetzt
Gerätespezifikationsbibliothek
Grundlegende Modellinformationen
-
Hersteller:Mud Technology International
-
Modell:MPCT-1000
Hersteller anzeigen Modelle anzeigen
Zusätzliche Information
Up to 1,000 GPM Cleaning
Trailer or Skid Mounted
Fully Self-Contained
Mixing, Pumping & Cleaning
Triplex Pump on Board
Generator Included
TRAILER SECTION
Rockover Design (floor of tank sets on the ground)
Heavy Duty Triple Axle Design Trailer
All D.O.T. approved lighting, Air Brakes
Unitized Body for added strength
Onboard Hydraulic landing legs mounted on front
Total length 52 feet (approximate)
Easy access ladder located on front of unit
TANK SECTION
Tank Section
3 section tank, 6,800+ gallon capacity (approximate)
Three inch square tubing frame on top and edges for added structural stability
Large Clean-outs located on shaker discharge side (large openings for each section tank)
1" bar grating covering all open areas on top Safety Handrails on perimeter of tank
Sloped floor for easy cleaning
TRIPLEX PUMP
Weatherford Lamb T425 HDD Triplex Pump
600 gpm & 900 psi @ 175 RPM
Triplex Pump mounted on unit with 12.5 L. John Deere Diesel, transmission, drive line, all safety guards
Gates Belt ratio reduction unit (for proper gear ratios)
100 foot Remote Pendant Station to control the triplex pump speed and volume
Safety Pop-off Valve and Pressure Gauge plumbed into unit
Inlet Suction filter mounted on triplex
All of the above mounted on the trailer section (no removal necessary)
PAINT
Urethane Industrial Paint System on exterior surfaces for added protection and durability
SOLIDS CONTROL
Four MTLS3P High G-Force Linear Shakers with "AWD" bed design
Pre-Tensioned Panel Shaker Screens (Available in various sizes)
Four 5" X 6" Magnum Centrifugal Pump Packages performing the following:
1) Pressure feed fluid to the mud hopper and jet guns
2) Pressure feed fluid to the De-sander cones
3) Pressure feed fluid to the De-silter cones
4) The fourth Centrifugal Pump is mounted near the rear of the trailer to supercharge fluid to the Triplex Pump
Desander Cones: 2-10"cones for 1,000 g.p.m. cleaning
Desilter Cones: 10-5" cones for 1,000 g.p.m. cleaning
High Shear/Low Pressure Mixing Hopper with replaceable venturi and sack table integrated into hopper
Submersed Jet Guns designed for Maximum Shear
All plumbing is hard piped
Suction valving on each centrifugal
ELECTRICAL
John Deere Generator Package 12 wire reconnectable 3 Phase generator sized to provide electricity for unit
Main Circuit breaker mounted on unit for safety
Independent On-Off controls conveniently located
110 volt stepdown transformer mounted on unit
110 volt Regulated Power Outlet mounted on unit
Night work lights placed on the front and rear of the unit for night operation
Heavy-Duty NEMA rated Starters for Durability
Electronic or standard overloads available
All wiring sized to perform specific functions, all starters in watertight box
Trailer or Skid Mounted
Fully Self-Contained
Mixing, Pumping & Cleaning
Triplex Pump on Board
Generator Included
TRAILER SECTION
Rockover Design (floor of tank sets on the ground)
Heavy Duty Triple Axle Design Trailer
All D.O.T. approved lighting, Air Brakes
Unitized Body for added strength
Onboard Hydraulic landing legs mounted on front
Total length 52 feet (approximate)
Easy access ladder located on front of unit
TANK SECTION
Tank Section
3 section tank, 6,800+ gallon capacity (approximate)
Three inch square tubing frame on top and edges for added structural stability
Large Clean-outs located on shaker discharge side (large openings for each section tank)
1" bar grating covering all open areas on top Safety Handrails on perimeter of tank
Sloped floor for easy cleaning
TRIPLEX PUMP
Weatherford Lamb T425 HDD Triplex Pump
600 gpm & 900 psi @ 175 RPM
Triplex Pump mounted on unit with 12.5 L. John Deere Diesel, transmission, drive line, all safety guards
Gates Belt ratio reduction unit (for proper gear ratios)
100 foot Remote Pendant Station to control the triplex pump speed and volume
Safety Pop-off Valve and Pressure Gauge plumbed into unit
Inlet Suction filter mounted on triplex
All of the above mounted on the trailer section (no removal necessary)
PAINT
Urethane Industrial Paint System on exterior surfaces for added protection and durability
SOLIDS CONTROL
Four MTLS3P High G-Force Linear Shakers with "AWD" bed design
Pre-Tensioned Panel Shaker Screens (Available in various sizes)
Four 5" X 6" Magnum Centrifugal Pump Packages performing the following:
1) Pressure feed fluid to the mud hopper and jet guns
2) Pressure feed fluid to the De-sander cones
3) Pressure feed fluid to the De-silter cones
4) The fourth Centrifugal Pump is mounted near the rear of the trailer to supercharge fluid to the Triplex Pump
Desander Cones: 2-10"cones for 1,000 g.p.m. cleaning
Desilter Cones: 10-5" cones for 1,000 g.p.m. cleaning
High Shear/Low Pressure Mixing Hopper with replaceable venturi and sack table integrated into hopper
Submersed Jet Guns designed for Maximum Shear
All plumbing is hard piped
Suction valving on each centrifugal
ELECTRICAL
John Deere Generator Package 12 wire reconnectable 3 Phase generator sized to provide electricity for unit
Main Circuit breaker mounted on unit for safety
Independent On-Off controls conveniently located
110 volt stepdown transformer mounted on unit
110 volt Regulated Power Outlet mounted on unit
Night work lights placed on the front and rear of the unit for night operation
Heavy-Duty NEMA rated Starters for Durability
Electronic or standard overloads available
All wiring sized to perform specific functions, all starters in watertight box
Diese Information dient nur zu Informationszwecken. HDD Broker LLC kann die Richtigkeit oder Vollständigkeit dieser Informationen nicht garantieren. Diese Informationen können vom Hersteller geändert werden. Einige Spezifikationen können sich je nach Modelljahr unterscheiden.